Обои MARBURG Montego №-30814

1. Read the instructions on the wallpaper and glue. Prepare glue (according to package instructions). 2. Make sure all wallpaper rolls have the same batch number... 3. Read the instructions on the wallpaper and glue. 4. Prepare the glue (according to the instructions on the package). 5. Make sure all wallpaper rolls have the same batch number. The same wallpaper from different batches may differ in color. 6. Prepare the wallpaper: cut the roll into panels of the desired length. Important: consider combining the pattern on the wallpaper! From a roll of wallpaper 10 m long, 3-4 panels are obtained, depending on the height of the room and the size of the rapport. 7. Fold the finished panels on a clean, flat surface (on a film spread on the floor) - one on top of the other, with the back side up, shifting each a few centimeters to the side. 8. Using a level or plumb line, draw a vertical line on the wall, stepping back from the corner by the width of the wallpaper minus one centimeter. Remember: you need to glue the wallpaper in the direction from the window! 9. In the event that the wallpaper is not glued to the ceiling, mark their upper border with a chopping cord. To mark the wall, use a paint that does not leave streaks on the wallpaper. 10. Apply glue to the back of the top sheet with a roller or brush. Try not to leave allowances, carefully coat the edges. 11. Unless otherwise indicated in the instructions, fold the smeared cloth with the ends towards the middle and roll up. 12. After ten minutes, the wallpaper will be saturated with glue and can be glued. 13. Expand the top edge of the cloth and attach it to the wall. Align the side edge of the panel along the plumb line. Unfold and glue the bottom. Attention: the edge of the panel adjacent to the corner must go onto the adjacent wall by at least 5-10 mm! 14. With a rubber roller, a special spatula or a dry cloth, smooth the surface of the wallpaper so that there are no air bubbles. 15. At the end of the work, cut off the top and bottom excess wallpaper evenly with a clerical or circular knife. A spatula can be used as a ruler. 16. It is advisable to paste over the entire room at once in one approach, in extreme cases - the wall from corner to corner, try not to leave a half-pasted wall. 17. Make sure that there are no drafts during work, otherwise the wallpaper may then lag behind the walls in places.

In this case, nothing can be changed, the wallpaper is produced in batches, and each subsequent batch may not have big differences in half a tone. If you start gluing wallpaper from another batch, starting from the corner, you won't see a ton differently. We recommend buying wallpaper with a small margin.

It’s just that it’s easier and more convenient to make a selection of wallpapers in catalogs, companion wallpapers immediately go, you, sitting at a comfortable table, can calmly and not in a forced environment look at everything, touch it and make the right choice from tens of thousands of patterns, shades and textures. For example, a catalog in which 50 pieces of samples is more convenient to take to an object and attach to the interior than to take 50 pieces of rolls with you.

According to the "Law on the Protection of Consumer Rights", it provides for the return of the purchased goods within 14 days if it does not fit in style or color. But subject to a number of conditions, the wallpaper remained unopened, not dented or scratched.

This is a wallpaper with an edge that is designed to protect the edges of the roll from damage. Wallpapering in this case occurs with an overlap, followed by cutting off excess edges.

According to the type of UV resistance, wallpapers are divided into the following types: - Moderate -Satisfactory -Good -Very good -Excellent. The most resistant to fading are wallpapers with markings on the roll in the form of two vertically arranged suns (one above the other).

Yes, these are hard vinyl wallpapers, very popular lately, which can be used for decorating any premises, as they easily tolerate high humidity and mechanical damage.

Yes, I have! We recommend using in the bathroom or toilet. In the kitchen, you can paste two types of wallpaper, in places of high humidity, use moisture-resistant wallpaper, and in the dining area, use other canvases you like.

There is nothing terrible in this, it is possible to stick with another manufacturer of glue, but the main thing is that the glue matches the type of wallpaper, non-woven, paper, moisture resistant.

Acrylic (denoted by the letter A) Paper (B) Foamed Vinyl (VV) Flat vinyl (PV) Embossed Vinyl (RV) Textile wallpaper (TKS) Structural wallpaper for painting (STR), Glass fiber (STL) Duplex embossed wallpaper

This can be done in several ways: -On the inside of the wallpaper -On the wall -Wallpaper with glue already applied at the factory

We recommend using a roller or a special spatula, it is possible to use a dry and clean rag.

There are two types of rapport, in height and lateral, rapport is the repetition of a pattern on a wallpaper canvas.

The basis of non-woven fabric (70%) is cellulose - the same material that is used for the production of ordinary paper, but differs from paper in greater density, wear resistance and strength. To the touch, the wallpaper resembles fabric, but outwardly it looks like paper. The advantages of non-woven wallpaper do not stretch when wet, and do not shrink when dried, if you plan to paint them, then this can be done up to 5 times. When sticking non-woven wallpaper, the glue should only be applied to the wall.

The most expensive type of wallpaper has a front part made of silk, cotton, linen, jute, viscose and other materials, the base is made of paper. Absolutely environmentally friendly, do not fade, perfectly absorb sound. The price of textile wallpaper is determined by the value of the material from which it is made. The main feature of fabric wallpapers is that they can be combined with the interior of any style. Among the shortcomings can be attributed not resistance to mechanical damage and moisture.

Vinyl wallpaper consists of two parts, the base and the outer decorative part, which has a layer of foamed polyvinyl chloride (popularly vinyl) of different thicknesses, thanks to this coating, the wallpaper can have very expressive reliefs, reflect light with transfusion effects, perfectly imitate leather, suede, ceramic tiles, natural fabrics, wood and much more. Of the minuses, this is not the ability to pass air and moisture.

On the rapport of the drawing, on the designations of the shifted drawing or not, the height of the drawing, sometimes it is recommended to glue the wallpaper in the opposite direction.

There are several main reasons, and the most common is that the walls are not properly processed, not sanded or primed. Drafts and temperature fluctuations in the room during wallpapering are also the cause of poor quality wallpapering.

This must be done without fail, according to the instructions for holding time for the material you are using, for a given time, the glue must penetrate into the fibers of the web, but not violate the integrity. You need to know that during impregnation, the wallpaper stretches in width by about 2.5%, and in length by 0.7%.

moisture resistant washable Super washable friction resistant Super washable abrasion resistant Impact resistant

There are several types of wallpaper that, when dismantled: completely removed, removed with plaster, with a separating top layer

We do not recommend using wallpapers from different batches, there will definitely be color discrepancies. If for some reason you purchased wallpaper from different parties, they must be glued to different walls.

We always recommend preparing the walls before gluing, the primer reduces the consumption of glue, gives better adhesion of the wallpaper to the wall, protects against the occurrence of fungus and mold.

Yes, of course, but first prepare the wall, it needs to be processed with sandpaper to create a rough surface.

Yes, it is possible, but only with "fresh" stains, it is enough to gently wipe with a damp sponge, and then dry.

You can stick decorative stickers (applications) on top of the wallpaper, if the wallpaper is paintable, you can repaint them, or stick a border at the bottom, which has a height of 30 cm to 100 cm.

Wallpaper consists of two components, a base and a cover. The base is a special layer in contact with the wall. The base can be made of paper, fabric. The coating is what is applied to the base and here the manufacturers have no limits to their imagination, using paper, fibers of plant, animal, mineral and artificial origin, metal, polymers, varnishes, paints and their combinations.

There are differences in the production technology and the material used. The simplest version of paper wallpaper is simplex, which has one layer of paper (consisting of two pressed parts, this is duplex). Of the advantages, this is of course not a high price, environmentally friendly, breathable. Of the minuses, they quickly burn out, it is easy to tear when pasting, you need an ideal surface for sticking.

Everyone knows that vertical stripes will visually increase the height, and horizontal stripes will increase the width of the room. If you divide the wall horizontally into two equal parts and place wallpaper on them, this will give the same effect as wallpaper with a stripe.

Now on all packs they write how many rolls or m2 there is enough glue, but don’t pay attention to this, this is a marketing ploy, uneven surfaces affect the consumption of glue, the choice of wallpaper base is non-woven, paper, vinyl, they all imply a different amount of glue applied to the wall and canvas. When we glue non-woven wallpaper, the glue needs to be applied only to the canvas, the walls do not need to be smeared, with paper wallpaper it is necessary to smear both the walls and the canvas itself. Glue for vinyl, non-woven, textile, glass, velor, embossed in a pack of 200 grams, diluted according to the instructions for 4 liters of warm water and it is enough to cover 30 m2. Special glue for paper wallpapers, diluted in 5 liters of water and it is enough for gluing 40 m2. For gluing heavy and textured wallpapers, we recommend thinning the glue thicker. We recommend that after calculating the amount of glue required, add another 10% to the total amount. Universal adhesives for all types of wallpaper that we recommend Metylan, Quelyd, KLEO OPTIMA, Exclusive, Axton, Moment.

If you plan to independently calculate the required number of wallpapers, take into account that: the length of the rolls is 10.5 meters, the width is 0.53 meters and with a ceiling height of more than 2.5 meters you will get only three canvases, consider the number and dimensions of the door, window openings or other decorative wall decoration (tiles, photo wallpapers), an important point is the purchase of wallpaper with a pattern, check with the seller which report, the location of the pattern, because in this case you will have to buy several rolls more, since their consumption increases by 1 ,5 - 2 times.

Yes, our online store offers exclusive and designer wallpapers from America, England, Germany and France.

For more reliable adhesion of wallpaper to the wall.

The glue is selected to the type of wallpaper (paper, vinyl, non-woven, textile), the composition of the glue has different components for better bonding and has a different amount of methyl cellulose - a retaining substance.

When sticking new wallpapers, it is advisable to remove the old ones, especially if they have a texture.

They need to be glued, to do this, soak the receded places a little, then apply special glue for the joints (the composition of this glue holds the gluing part better).

There may be several variants of this problem, these are: not plastered wall, old wallpaper remained, wallpaper dried for too long, foreign objects (protruding metal or wooden parts) were not removed.

Smooth wallpapers are better suited to the design of large spaces, in a small room it is better to use wallpaper with a texture that will reflect light better and thereby increase the space. To add volume to the room, a wallpaper canvas with a shiny texture will help, and it doesn’t matter that you choose a metallic coating or silk-screen printing. Matte wallpaper is better to glue in large rooms. If you plan to use a large wallpaper pattern when decorating an apartment, we advise you to place it on one view wall and make it the accent of the room, and if the pattern is not large, such canvases are suitable for all walls of the room. need to act

Free docking when wallpapering is when you simply cut off the right amount of canvas and do not join the pattern, usually it is vertical striped or plain wallpaper.

This is when the pattern is aligned horizontally, the pattern on the left strip and the right one should ideally connect, as a standard, the distance through which the pattern repeats is indicated on the wallpaper label.

This is when the pattern is located diagonally and usually shifts by half the canvas, the report can also be seen on the wallpaper label.

In this case, most likely, the wrong color scheme was chosen, regarding the placement of windows and artificial lighting. The buyer chooses wallpaper in the catalog, and when they are on the wall in bulk, the color becomes saturated. You need to increase the lighting or re-paste the wallpaper.